Naim-audio NDX Bedienungsanleitung PDF herunterladen (Seite 2)

NDX Quick Start Guide English

1 Installing and Connecting

• Stand the NDX on an appropriate, stable surface. Make sure it is well ventilated.

• Check that the mains supply specified on the NDX rear panel is appropriate for your

territory. Connect the NDX to the mains using the supplied cable but do not switch it on until

all other connections have been made.

• Identify the Signal Ground Switch and select the “chassis” option unless the NDX is

connected in a hi-fi system incorporating another earthed source component (all Naim CD

players, for example), or mains “hum” is audible through the loudspeakers when the NDX is

switched on.

• To play audio from a UPnP™ server or from internet radio stations, the NDX network socket

must be connected to a router using an Ethernet cable, or its Wi-Fi Antenna must be fitted.

Internet radio also requires a high-speed internet connection.

• If the NDX DAB/FM module is fitted, a suitable aerial should be connected to the DAB/FM

aerial socket. The DAB/FM module cannot operate without an aerial. Contact your local

Naim retailer or distributor for advice on selecting and installing an aerial.

• If the NDX is to play audio files stored on an iPod, iPhone or on USB memory hardware,

connect it using an appropriate cable, if necessary, to the front panel USB socket.

• If any external S/PDIF digital audio sources are to be used with the NDX, connect them,

using the appropriate BNC coaxial, phono coaxial or optical cables, to the digital inputs.

• Connect one of the NDX outputs to an appropriate preamplifier or external DAC input. The

NDX DIN output is the default active analogue output. To select an alternative analogue

output, press the handset setup key ( ) once the NDX is switched on and select Analogue

Outputs. Select Digital Output to activate the digital output.

• NDX control can be linked using System Automation to the control of some Naim

preamplifiers, CD players and the Naim DAC. System Automation enables for example,

preamplifier inputs to be selected via the NDX, or for n-Stream transport functions to control

a CD player. To take advantage of System Automation, connect one of the NDX Remote

Out sockets to a preamplifier, CD player or DAC Remote In socket. Use a cable terminated

with a 3.5mm jack plug at one end and a 3.5mm jack or phono plug as necessary at the

other end.

Note: NDX System Automation is switched off by default. A full description of its use can be

found in the NDX Reference Manual.

Full NDX installation and operational information can be found in the Reference Manual

available on line at www.naimaudio.com

Note: If your NDX is to be

XPS or 555 PS power supply,

remove the NDX power

supply upgrade socket

link plug and connect the

external power supply using

the appropriate Burndy

cable. Do not connect the

NDX mains cable.

Important: XPS power supplies

with serial numbers below

188015 are not compatible

with the NDX and should not

be used. Contact your local

retailer or distributor for more

information.

mains input

and fuse

power switch

network

socket

DAB/FM aerial

socket

signal ground

switch

digital

output

wireless network

(Wi-Fi) antenna

socket

power supply

upgrade socket

(link plug tted)

remote

out 1 & 2

digital inputs

3, 2 & 1

analogue

output

(phono)

analogue

output

(DIN)

USB update

interface

1 2 3 4 5 6 7 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Naim-audio NDX Bedienungsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Naim-audio NDX